cui.DockDialogBar and cui.FloatDialogBar

 

cui.DockDialogBar <RolloutFloater_or_Rollout> <dockflag>

This method docks a registered dialog bar to the specified docking area.

Note: These methods are not available in Autodesk VIZ.

<RolloutFloater_or_Rollout>

This parameter must be a RolloutFloater created with NewRolloutFloater or a Rollout that has been installed in a dialog using CreateDialog, and has been registered using cui.RegisterDialogBar.

<dockflag>

Specifies the area to dock the dialog bar to. Can be one of the following:

#cui_dock_left -- dock to the left
#cui_dock_top -- dock to the top
#cui_dock_right -- dock to the right
#cui_dock_bottom -- dock to the bottom

Note:

Attempting to set the <dockflag> to any other value than the listed above will cause unpredictable results. Always dock to one of the four sides.

 

cui.FloatDialogBar <RolloutFloater_or_Rollout>

This method will float a registered dialog bar.

<RolloutFloater_or_Rollout>

This parameter must be a RolloutFloater created with NewRolloutFloater or a Rollout that has been installed in a dialog using CreateDialog, and has been registered using cui.RegisterDialogBar.

See also

CreateDialog

DestroyDialog

GetDialogPos and SetDialogPos

cui.getDockState